6
Tool operators and maintenance personnel must always comply with the safety precautions given in this manual and on
the stickers and tags attached to the tool and hose.
These safety precautions are given for your safety. Review them carefully before operating the tool and before performing
general maintenance or repairs.
Supervising personnel should develop additional precautions relating to the specifi c work area and local safety regula-
tions. If so, place the added precautions in the space provided in this manual.
The CS25/28 Hydraulic Pole Chain Saw will provide safe and dependable service if operated in accordance with the
instructions given in this manual. Read and understand this manual and any stickers and tags attached to the tool and
hoses before operation. Failure to do so could result in personal injury or equipment damage.
• Operator must start in a work area without bystanders. The operator must be familiar with all prohibited work areas such
as excessive slopes and dangerous terrain conditions.
• Establish a training program for all operators to ensure safe operation.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor.
• Always wear safety equipment such as goggles, ear, head protection, and safety shoes at all times when operating the
tool.
• Do not overreach. Maintain proper footing and balance at all times.
• Do not inspect or clean the tool while the hydraulic power source is connected. Accidental engagement of the tool can
cause serious injury.
• Supply hoses must have a minimum working pressure rating of 2500 psi/175 bar.
• Be sure all hose connections are tight.
• The hydraulic circuit control valve must be in the “OFF” position when coupling or uncoupling the tool. Wipe all couplers
clean before connecting. Use only lint-free cloths. Failure to do so may result in damage to the quick couplers and cause
overheating of the hydraulic system.
• Do not operate the tool at oil temperatures above 140°F/60°C. Operation at higher oil temperatures can cause operator
discomfort and may damage the tool.
• Do not operate a damaged, improperly adjusted, or incompletely assembled tool.
• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by au-
thorized and properly trained personnel.
• Do not exceed the rated limits of the tool or use the tool for applications beyond its design capacity.
• Always keep critical tool markings, such as lables and warning stickers legible.
• Always replace parts with replacement parts recommended by Stanley Hydraulic Tools.
• Check fastener tightness often and before each use daily.
• Do not wear loose fi tting clothing when operating the tool.
SAFETY PRECAUTIONS
To Next Page
Loading...