G
B
16
1. PRECAUTIONS
An ACOUSTIC PRESSURE value of 4 m. corresponds
to the ACOUSTIC POWER value stated on the yellow
label located on the compressor, minus 20 dB.
THINGS TO DO
● The compressor must be used in a suitable
environment (well ventilated with an ambient
temperature of between +5°C and +40°C) and
never in places affected by dust, acids, vapors,
explosive or flammable gases
● Always maintain a safety distance of at least 4 meters
● Any coloring of the belt guards of the compressor
during painting operations indicates that the distance
● Insert the plug of the electric cable in a socket of
suitable shape, voltage and frequency complying
● Use extension cables with a maximum length of 5
●
The use of extension cables of different length and also
● Always use the switch I/O to switch off the
●
● When operating, the compressor must be placed on
THINGS NOT TO DO
● Never direct the jet of air towards persons, animals
your eyes against flying objects that may be lifted by
●
Never direct the jet of liquids sprayed by tools connected
● Never use the appliance with bare feet or wet hands
● Never pull the power cable to disconnect the plug
● Never leave the appliance exposed to adverse
● Never transport the compressor with the receiver
●
●
Keep children and animals at a distance from the
● This appliance is not intended for use by persons
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by
● Children should be supervised to ensure that they do
● Do not position flammable or nylon/fabric objects
● Never clean the compressor with flammable liquids
●
●
The compressed air produced by the compressor
cannot not be used for pharmaceutical, food or medical
purposes except after particular treatments and cannot
THINGS YOU SHOULD KNOW
●
To avoid overheating of the electric motor, this
compressor is designed for intermittent operation
as indicated on the technical dataplate
case of overheating, the thermal cutout of the motor
trips, automatically cutting off the power when the
●
To facilitate restart of the compressor, in addition
to the operations indicated, it is important to
return the button of the pressure switch to the OFF
position and then to ON again (paragraph 5.4).
●
The compressors are fitted with a pressure switch
equipped with a delayed closing air discharge valve
D 200/8/6 - D
115/8/6 SIL
Therefore venting of air from this valve
● All the compressors are fitted with a safety valve
that is tripped in the case of malfunctioning of the
● When fitting a tool, the flow of air in output must be
●
When using compressed air, you must know and comply
with the safety precautions to be adopted for each type
Preserve this handbook for future reference.
To Next Page
Loading...
