Stanley D 200/8/24 Instruction Manual

G
B

2. LAYOUT (Fig. 1)
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
3. SCOPE OF USE
The compressor is designed for generating compressed

Please note that our equipment has not been designed

Our warranty will be voided if the machine is used
in commercial, trade or industrial businesses or for



operator and not the manufacturer will be liable for any

4. POINTS TO NOTE WHEN SETTING
UP THE COMPRESSOR
     
Report any damage immediately to the company

 

 
 
 
 The compressor may only be used in suitable rooms



 
It is prohibited to use the compressor in areas where

5. ASSEMBLY AND STARTING
Warning!
You must fully assemble the appliance before
using it for the first time.
5.1 Fitting the wheels (Fig. 3, 4 & 5)

● 
Assembly by sequence: a, b, c, d, e
●  
●  
5.2 Fitting the supporting foot (ref. 4)

5.3 Voltage
The compressor is equipped with a mains cable with


       
the mains voltage complies with the specifications on




5.3.1 Connection of the mains plug (electrical
information for the BS plug)
Important!
The wires in the mains lead fitted to this product are

● This productis doubleinsulated andtherefore
does not require a connection to earth.
● The3pinplugmustcomplytoBS1363/A.
● FusemustcomplytoBS1362.

requires replacement it must be wired in accordance
with the following instruction:
Do not connect the brown (live) or blue (neutral) to
the earth pin marked ‘E’ on the 3 pin plug.
Connect the Blue wire to the terminal marked Neutral
        

the cord grip and that the wires are not trapped when

          

If in doubt consult a qualified electrician

Stanley D 200/8/24 Specifications

General

Brand	Stanley
Model	D 200/8/24
Category	Air Compressor
Language	English