Stanley FatMax FME720 - Mitre Clamp; Adjusting Bevel Stops; Adjusting the Fence; Bench Mounting

12
ENGLISH
(Original instructions)
u Adjust the fence to be as close to the blade as practical to
provide maximum work piece support, without interfering
with the up and down movement of the arm.
u Tighten the high sliding fence clamp (20) to secure the
fence in place.
Warning! The guide groove can become clogged with saw-
dust. Use a stick or low pressure air to clear the guide groove.
Bevel cut
u Make sure that the high sliding fence is adjusted to the
correct orientation before adjusting the bevel angle.
Note: The saw is tted with a special 33.9° bevel pin (23) for
special crown moulding.
u Loosen the bevel lock handle (30) (g. F) and move the
cutting head to the required angle. Tighten the bevel lock
handle (30).
u Operate the on/off switch, then press the release lever
(36) when the saw reaches full speed, push the main
operating handle (2) down slowly, cutting through the
workpiece.
u When the saw reaches full speed, push the main operat-
ing handle (2) down slowly, cutting through the leading
edge of the workpiece.
u Slowly move the main operating handle (2) toward the
fence to complete the cut.
u Release the on/off switch (3) and allow the blade to stop
before allowing the cutting head to rise.
u Make sure that the arm is securely locked when bevelling.
Compound cut
u Make sure that the high sliding fence is adjusted to the
correct orientation before adjusting the bevel angle to
make a compound cut.
A compound cut is a combination of mitre cut and bevel cut.
u Switch the laser on/off switch (1) to on.
u Refer to the above procedures to perform this cut.
u When the saw reaches full speed, push the main operat-
ing handle (2) down slowly, cutting through the leading
edge of the workpiece.
u Slowly move the main operating handle (2) toward the
fence to complete the cut.
u Release the on/off switch (3) and allow the blade to stop
before allowing the cutting head to rise.
Base moulding cut
Base moulding can be cut vertical against the fence or at on
the table.
u Refer to the following table:
Settings
Vertical position
(back of moulding is
against the fence)
Horizontal position
(back of moulding is
at on the table)
Bevel angle 0 º 45 º
Moulding position Left side
Right
side
Left side
Right
side
Inside
corner
Mitre angle
Left at
45 º
Right at
45 º
0 º 0 º
Moulding
position
Bottom
against
table
Bottom
against
table
Top
against
nce
Bottom
against
fence
Finished
side
Keep left
side of
cut
Keep
right side
of cut
Keep left
side of
cut
Keep left
side of
cut
Settings
Vertical position
(back of moulding is
against the fence)
Horizontal position
(back of moulding is
at on the table)
Bevel angle
0 º 45 º
Outside
corner
Mitre angle
Left at
45 º
Right at
45 º
0 º 0 º
Moulding
position
Bottom
against
table
Bottom
against
table
Top
against
nce
Bottom
against
fence
Finished
side
Keep left
side of
cut
Keep
right side
of cut
Keep
right side
of cut
Keep
right side
of cut