To Next PageTo Next PageWhy does my Stanley SBH20 shut off abruptly?
If your Stanley Drill shuts off abruptly, it might be due to the battery pack reaching its maximum thermal limit. In this case, allow the battery pack to cool down. Alternatively, the battery may be out of charge; place it on the charger and allow it to charge.
Why will my Stanley Drill not start?
If your Stanley Drill doesn't start, it could be due to a couple of reasons. First, check that the battery pack is installed properly. Second, the battery pack may not be charged, so verify its charging requirements.
What to do if Stanley SBH20 Drill starts immediately upon inserting battery?
If your Stanley Drill starts immediately upon inserting the battery, the switch might have been left in the “on” position. To prevent this, ensure the switch is moved to the “off” position before inserting the battery.
How to fix Stanley Drill battery pack will not charge?
If the battery pack for your Stanley Drill won't charge, there are a few things to check: 1. Make sure the battery pack is fully inserted into the charger until the LED lights come on. 2. Verify that the charger is plugged into a working outlet. 3. Ensure the surrounding air temperature is suitable, above 40 degrees F (4.5ºC) and below 105 degrees F (+40.5ºC). Move the charger and battery pack if necessary.
What to do if Stanley SBH20 unit will not start?
If your Stanley Drill unit won't start, it could be due to the battery pack not being installed properly, so check the battery pack installation. Alternatively, the battery pack might not be charged, so check the battery pack charging requirements.
Why won't my Stanley Drill battery pack charge?
If your Stanley Drill battery pack won't charge, there are a few possible reasons: * The battery pack might not be inserted into the charger. Insert the battery pack into the charger until the LED lights. * The charger might not be plugged in. Plug the charger into a working outlet. * The surrounding air temperature might be too hot or too cold. Move the charger and battery pack to a surrounding air temperature of above 40°F (4,5°C) or below 105°F +40,5°C).
What to do if Stanley Drill starts immediately when inserting battery?
If your Stanley Drill starts immediately upon inserting the battery, the switch has likely been left in the “On” position. The switch must be moved to “Off” to prevent the tool from immediately starting when the battery is inserted.
General