(Original instructions) ENGLISH
5
Lithium-ion cells and batteries have been tested to section
38.3 of the UN Recommendations on the Transport of
Dangerous Goods Manual of Tests and Criteria.
In most instances, shipping a STANLEY battery pack will be
excepted from being classified as a fully regulated Class 9
Hazardous material. In general, the two instances that require
shipping Class 9 are:
1. Air shipping more than two STANLEY lithium-ion battery
packs when the package contains only battery packs (no
tools), and
2. Any shipment containing a lithium-ion battery with an
energy rating greater than 100 watt hours (Wh). All
lithium-ion batteries have the watt hour rating marked on
the pack.
Regardless of whether a shipment is considered excepted or
fully regulated, it is the shipper’s responsibility to consult the
latest regulations for packaging, labeling/marking and
documentation requirements.
Transporting batteries can possibly cause fire if the battery
terminals inadvertently come in contact with conductive
materials. When transporting batteries, make sure that the
battery terminals are protected and well insulated from
materials that could contact them and cause a short circuit.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the time
the document was created. However, no warranty, expressed
or implied, is given. It is the buyer’s responsibility to ensure
that its activities comply with the applicable regulations.
BATTERY PACK
Storage recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool, dry place out of the
charger for optimal results.
Note: Battery packs should not be stored completely depleted
of charge. The battery pack will need to be recharged before
use.
LABELS ON CHARGER AND BATTERY PACK
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See Technical Data for charging time.
100% Battery charging.
100% Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
Charge STANLEY battery packs only with
designated STANLEY chargers. Charging battery
packs other than the designated STANLEY batteries
with a STANLEY charger may make them burst or
lead to other dangerous situations.
Do not incinerate the battery pack.
Position of date barcode (Fig 1)
The date code (a), which also includes the year of
manufacture, is printed into the underside of the housing.
Example:
2015 XX XX
Year of Manufacture
PACKAGE CONTENTS
The package contains:
1 Battery charger
1 Instruction manual
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
To Next Page
Loading...
Need help?
General
