ENGLISH (Original instructions)
6
ELECTRICAL SAFETY
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your STANLEY charger is double insulated in
accordance with EN 60335; therefore no earth wire
is required.
• If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the STANLEY
service organisation.
USING AN EXTENSION CABLE
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for the
power input of your charger (see Technical Data). The
minimum conductor size is 1 mm2; the maximum length is 30
m. When using a cable reel, always unwind the cable
completely.
MAINTENANCE
Your STANLEY power tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
WARNING: To reduce the risk of serious
personal injury, turn tool off and disconnect
battery pack before making any adjustments or
removing/ installing attachments or accessories. An
accidental start-up can cause injury.
The charger is not serviceable. There are no serviceable parts
inside the charger.
• Do not attempt to repair the charger. To assure product safety
and reliability, repairs, maintenance, and adjustments should
be performed by authorized STANLEY service centers.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the
AC outlet before cleaning. Dirt and grease may be removed
from the exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any cleaning
solutions.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your STANLEY product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product available
for separate collection.
STANLEY provides a facility for the collection and
recycling of STANLEY products once they have
reached the end of their working life. To take
advantage of this service please return your product to any
authorised repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local STANLEY office at the address
indicated in this manual. Alternatively, a list of authorised
STANLEY repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com.
BATTERIES
STANLEY batteries can be recharged many times.
At the end of their useful life, discard batteries with
due care for our environment:
• Run the battery down completely, then remove it from the
tool.
• NiCd, NiMH and Li-Ion batteries are recyclable. Take them
to any authorized repair agent or a local recycling station.
NOTES
STANLEY’s policy is one of continuous improvement to our
products and as such, we reserve the right to change product
specifications without prior notice. Standard equipment and
accessories may vary by country. Product specifications may
differ by country.
Complete product range may not be available in all countries.
Contact your local STANLEY dealers for range availability
SERVICE INFORMATION
STANLEY offers a full network of company-owned and
authorized service locations. All STANLEY Service Centers are
staffed with trained personnel to provide customers with
efficient and reliable power tool service. For more information
about our authorized service centers and if you need technical
advice, repair, or genuine factory replacement parts, contact
the STANLEY location nearest you.
TECHNICAL DATA
SC201 SC202
Input Voltage V
AC
220-240 220-240
Output Voltage V
DC
18 18
Output Current(DC) A 1.0 2.0
Approx. charge time min 75 (1.3Ah) 60 (2.0Ah)
Battery Li-Ion Li-Ion
To Next Page
Loading...
Need help?
General
