ENGLISH • 25
LED work light
When drill is activated by pulling the trigger switch (1), the
integrated LED work light (8) will automatically illuminate the
work area.
Note: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Bit tip storage
A bit storage slot (9) is built into the base of the tool.
MAINTENANCE
Your Stanley Fat Max tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning. Your charger does not
require any maintenance apart from regular cleaning.
Warning! Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
f Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
f Regularly clean the motor housing using a damp
cloth. Do not use any abrasive or solvent-based cleaner.
f Regularly open the chuck and tap it to remove any
dust from the interior.
¡Important! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be performed
by authorized service centers or other qualified organizations,
always using identical replacement parts. Unit contains no
user service able parts inside.
ACCESSORIES
Warning! Since accessories, other than those offered
by STANLEY have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only STANLEY recommended
accessories should be used with this product.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be disposed
of with normal household waste. Should you find one day
that your STANLEY product needs replacement, or if it is of
no further use to you, do not dispose of it with household
waste. Make this product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
BATTERIES
STANLEY batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
f Run the battery down completely, then remove it
from the tool.
f NiCd, NiMH and Li-Ion batteries are recyclable.
Take them to any authorized repair agent or a local
recycling station.
SERVICE INFORMATION
STANLEY offers a full network of company-owned
and authorized service locations. All STANLEY Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service.
For more information about our authorized service
centers and if you need technical advice, repair,
or genuine factory replacement parts, contact
the STANLEY location nearest you.
SPECIFICATIONS SCD20
Voltage 20V MAX
No-load speed 0 - 350/min (rpm)
0 - 1500/min (rpm)
Torque 45 Nm (33,2 ft-lb)
Chuck 1/2” (13mm)
CHARGER SC201
Voltage
B3 120V ~ 60Hz
Output Voltage 20V
MAX
Input current 0,4Amp
Output current 1A
Weight 0,445kg (0,98lb)
CHARGER SC202
Voltage
B3 120V ~ 60Hz
Output Voltage 20V MAX
Input current 0,9Amp
Output current 2A
Weight 0,445kg (0,98lb)
BATTERY SB20C
Voltage 20V MAX*
Capacity 1,3Ah
Type Lithium-Ion
BATTERY SB20D
Voltage 20V MAX*
Capacity 2,0Ah
Type Lithium-Ion
To Next Page
Loading...
