For more information about our authorized service centers and
if you need technical advice, repair, or genuine factory
replacement parts, contact the STANLEY location nearest you.
TECHNICAL DATA
Noise Values
The total noise values determined in accordance with
NOISE
The declared noise emission values stated in the technical data
and the declaration of conformity have been measured in
accordance with a standard test method provided by EN 62841
and may be used for comparing one tool with another. The
declared noise emission value may also be used in a
preliminary assessment of exposure.
WARNING! The noise emission value during actual
use of the power tool can differ from the declared
value depending on the ways in which the tool is
used. The noise level may increase above the level
stated.
When assessing noise exposure to determine safety measures
required by 2002/44/EC to protect persons regularly using
power tools in employment, an estimation of noise exposure
should consider, the actual conditions of use and the way the
tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
TWO YEARS WARRANTY
If your STANLEY product becomes defective due to faulty
materials or workmanship within 24 months from the date of
purchase, STANLEY guarantees to replace all defective parts
free of charge or – at our discretion – replace the unit free of
charge provided that:
• The product has not been misused and has been used in
accordance with the instruction manual;
• The product has been subject to fair wear and tear;
• Repairs have not been attempted by unauthorized persons;
• Proof of purchase is produced;
• The STANLEY product is returned complete with all original
components;
• The product hasn’t been used for hire purposes.
If you wish to make a claim, contact your seller or check the
location of your nearest authorised STANLEY repair agent in
the STANLEY catalogue or contact your local STANLEY office
at the address indicated in this manual. A list of authorised
STANLEY repair agents and full details of our after sales
service is available on the internet at: www.2helpU.com
SST1800
TABLE SAW
Type 2
Voltage V
AC
220-240
Frequency Hz 50-60
Power input W 1800
No-load speed
min
-1
4800
Blade diameter mm 254
Bore Size mm 30
Blade kerf mm 2.8
Blade body thickness mm 1.8
Riving knife thickness mm 2.5
Table size mm 560x680
Max. cutting depth at 45º mm 50
Max. cutting depth at 90º mm 80
Blade bevel range 0 - 45º
Weight kg 28.8
Level of sound pressure according to EN62841;
Sound pressure (L
pA
) dB(A) 87.5
Sound pressure uncertainty (K
pA
) dB(A) 3
Sound power (L
WA
) dB(A) 103.5
Sound power uncertainty (K
WA
) dB(A) 3
EC declaration of conformity
MACHINERY DIRECTIVE
SST1800 - Table Saw
STANLEY declares that these products described under
"technical data" are in compliance with: 2006/42/EC,
EN62841-1:2015+AC:2015,
EN62841-3-1:2014+AC:2015 + A11:2017.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact STANLEY
at the following address or refer to the back of the manual.
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
STANLEY.
Becky Cotsworth
Director – Outdoor Products Group
STANLEY FATMAX Europe, Egide Walschaertsstraat14-18,
2800 Mechelen, Belgium
10.2019
(Original instructions) ENGLISH
15
To Next Page
Loading...
