45
English (original instruction)
Problem Possible Causes Solution
Cutter head height difficult
to adjust.
• Dirty elevation spindle. • Clean and lubricate spindle.
• Worn chain. • Have service performed by an
authorized service center.
Will not start. • Not plugged in. • Check power source.
• Blown circuit. • Replace fuse, reset breaker, or call
electrician.
• Motor failure. • Have service performed by an
authorized service center.
• Loose wire. • Have service performed by an
authorized service center.
• ON/OFF switch
malfunction.
• Have service performed by an
authorized service center.
• Motor is overloaded. • Push reset button.
Interrupted operation. • Unit overloaded. • Reduce load.
• Circuit overloaded. • Operate on circuit separate from
other appliances or motors or
connect to circuit with adequate
amp rating.
Cutter head will not lower
to plane material.
• Turret stop setting too high. • Lower turret stop setting.
To Next Page
Loading...