Why does my Stanley Saw make unsatisfactory cuts?
Unsatisfactory cuts from your Stanley Saw can stem from several causes: * A dull blade – replace the blade. * A blade mounted backward – turn the blade around. * Gum or resin on the blade – remove the blade and clean it. * Using the incorrect blade for the job – change to the correct blade.
Why does my Stanley STST1825 Saw kick material back?
Material can kick back from the blade of your Stanley Saw for several reasons: * The rip fence might be out of adjustment – align the rip fence with the miter gauge groove. * The splitter might not be in line with the blade – align the splitter with the blade. * You might be feeding stock without the rip fence – install and use the rip fence. * The blade might be dull – replace the blade. * The bevel knob might not be tight – tighten the knob.
What to do if my Stanley Saw will not start?
If your Stanley Saw won't start, here are a few things to check: * Ensure the saw is properly plugged into a power source. * Check for a blown fuse or tripped circuit breaker and replace or reset it. * Inspect the power cord for damage; if damaged, have it replaced by an authorized service center. * Look for debris in the ON/OFF switch and clean it out.
Why does Stanley Saw vibrate excessively?
Excessive vibration in your Stanley Saw can be due to: * The saw not being securely mounted to the workbench – tighten all mounting hardware. * The bench or stand being on an uneven floor – re-position it on a flat, level floor. * A damaged saw blade – replace the blade.
What to do if material pinched the blade when ripping with Stanley STST1825 Saw?
If the material is pinching the blade when ripping with your Stanley Saw, it could be because: * The rip fence is not aligned with the blade – check and adjust the rip fence. * You're using warped wood, and the edge against the fence isn't straight – select another piece of wood.
Why Stanley STST1825 Saw blade does not come up to speed?
If the blade of your Stanley Saw does not come up to speed, and the reset trips too easily, it might be because: * The extension cord is too light or too long – replace the extension cord with an adequate size. * There is low house voltage – contact an electrician.
How to clean Stanley STST1825 Saw blade elevation/tilting mechanism?
If the blade of your Stanley Saw does not raise or tilt freely, it is probably because of sawdust and dirt in the elevation/tilting mechanism. Brush or blow out any loose dust and dirt.
General| Idle speed (max) | 4800 RPM |
|---|---|
| Cutting depth (45º) | 56 mm |
| Cutting depth (90º) | 76 mm |
| Diamond disc | - |
| Saw blade type | Single blade |
| Product color | Black, Grey, Yellow |
Weight and Dimensions| Depth | 505 mm |
|---|---|
| Width | 530 mm |
| Height | 580 mm |
To Next Page
