7
ENGLISH
Step 4
Now place and connect the ends of the top and center
frame supports to the frame. Take care to ensure that
the supports are positioned as shown in Fig. B5.
Step 5
Once you are satisfied that the frame is assembled
correctly, fully tighten ALL the bolts.
Finally, assemble the 4 foot pads to the bottom of
each leg (see Fig. B6).
Fitting the table saw to the stand (see FIG. C1, C2)
There are four mounting holes on the base of the saw. 4 cor-
responding mounting holes are located on the top plane of
the stand. Put the table saw on the stand, match the holes on
the base of the saw with the holes on the stand, and secure
them with the 4 bolts (b) provided. DO fully fasten.
Adjusting the splitter (FIG. D1-D3)
The splitter (3) has two positions: storage position (Fig. D1)
and working position (Fig. D2). The splitter is in the storage
position when you take it out of the package.
To place the splitter in the working position:
a. Remove the blade throat plate.
b. Raise the blade up to the highest position by turning
the blade control wheel counterclockwise. Set the
bevel at 0°. Make sure the bevel is locked tight.
c. Release the splitter locking lever by pulling the lever up.
d. Pull the splitter up to the working position. The two work-
ing position holes should align with the two pins on the fixture.
e. Lock the splitter by pushing the splitter locking lever down.
Note: Make sure the splitter is locked securely.
f. Place the blade throat plate back on.
To adjust the splitter to be in the storage position:
Repeat steps a to c described above and slide the splitter
down to the storage position. Lock the splitter locking lever.
Lower the blade to the lowest position. The splitter should be
under the saw table.
To adjust the height of the splitter (Fig. D3)
51
4
B5
B6
D1
D2
Slots Working Position Holes
Locking Level
3 2 1
C1
b
b
C2
To Next Page
Loading...
