10
(Original instructions)
EN © 2016 English
EN
3.1.18 Warning. DO NOT move the appliance by pulling on the ELECTRIC CABLE.
3.1.19
Warning. DO NOT allow vehicles to drive over the high pressure hose.
3.1.20
Warning. DO NOT move the appliance by pulling on the high pressure hose.
3.1.21
Warning. When directed towards tyres, tyre valves or other pressurised
components, the high pressure jet is potentially dangerous. Do not use the
rotating nozzle kit, and always keep the jet at a distance of at least 30 cm during
cleaning.
3.1.22
Warning. The use of non-original accessories and any other spare parts not spe-
cifically intended for the model in question is prohibited. All modifications to
the appliance are prohibited; any modifications shall render the Declaration of
Conformity null and void and relieve the manufacturer of all liability under civil
and criminal law.
3.2 SAFETY “MUSTS”
3.2.1
Warning. All electrical conductors MUST BE PROTECTED against the water jet.
3.2.2
Warning. The electric supply connection must be made by a qualified electrician
and comply with IEC 60364-1. Either a residual current device that will cut off
the power supply if the leakage current to earth exceeds 30 mA for 30 ms or a
ground fault interrupt device must be installed.
3.2.3
Warning. DURING start-up, the appliance may cause network noise.
3.2.4
Warning. Use of a residual current breaker (RCB) will provide additional protection
for the operator (30 mA).
3.2.5
Warning. Models supplied without plug must be installed by qualified staff.
3.2.6
Warning. Use only approved electrical extension leads with suitable conductor
cross-section.
3.2.7
Warning. Always turn off the switch when leaving the appliance unattended.
3.2.8
Warning. High pressure may cause parts to rebound: wear all the protective
clothing (PPE) and equipment needed to ensure the operator’s safety.
3.2.9
Warning. Before doing work on the appliance, REMOVE the plug.
3.2.10
Warning. Before pressing the trigger, GRIP the gun firmly to counteract the recoil.
To Next Page
Loading...
