14 15
PIC. 16
STARTING YOUR PRESSURE WASHER
1. Check oil level.
2. Check and fill fuel.
3. Connect garden hose to cold water source.
Do not turn on!
4. Connect garden hose to garden connection on pump.
5. Select position of nozzle, see page 11.
6. If using detergent fill and select bottle refer page 14,
Pic. 11.
7. Turn choke to start by sliding the choke lever to the
LEFT, (START) Pic 12.
8. Turn fuel on by rotating tap to the left until vertical,
Pic 13.
9. Push engine switch to “1”, refer Pic. 14.
10. Pull the recoil starter slowly until engaged, then
pull briskly. This step may need to be repeated until
pressure washer engine starts, this can take up to
about 12 pulls, Pic 15.
Warning: Never pull the recoil once the engine has
started. Any damage caused will not be covered
under warranty.
11. Once started, slide choke to right (RUN) Pic. 12.
12. Turn cold water source on.
13. Release safety lock on trigger, push lever down.
14. Squeeze trigger on wand. Hold down until all air
is purged and a steady stream of water is passing
through, Pic 16.
15. Release trigger to stop water flow.
STOPPING YOUR PRESSURE WASHER
To stop your pressure;
1. Turn cold water supply off.
2. Squeeze gun trigger, releases some water and pressure.
3. Turn fuel tap off, refer Pic. 13.
4. Push engine switch off “0”.
5. Once engine has stopped, squeeze gun trigger, releases
some water and pressure.
6. Disconnect the garden hose from pressure pump and
garden tap.
7. Lock the gun, push lever up.
8. Tidy up hose, gun and lance.
9. Allow pressure washer to cool about 1 hour before
wiping down and store appropriately.
PIC. 13
CHOKE
PIC. 12
PIC. 14
Starting Handle
PIC. 15
FUEL
START RUN
To Next Page
Loading...
