13/146
* under favourable conditions (good target sur-
face, room temperature) up to 10 m (33 ft).
Under unfavourable conditions such as bright
sunlight, a very weakly reflecting target surface or
large temperature fluctuations, the error can
increase to ± 0.25 mm/m (± 0.003 in/ft) for dis-
tances over 10 m (33 ft).
12.1 Electromagnetic compatibil-
ity (EMC)
Despite the compliance with all requirements of
the corresponding directives and norms, a distur-
bance of other devices is possible.
12.2 Laser classification
The Stanley TLM generates a visible laser beam
that is emitted on the front of the device.
The device complies with laser class 2 according
to:
Î IEC60825-1: 2007 Safety of laser products
Laser class 2 products
Do not look into the laser beam and do not
unnecessarily aim at other persons . The eye is
usually protected by preventive reactions such as
the eyelid closure reflex.
Labels
Position of the type label see drawing C
13 Care
 Clean the device with a damp, soft cloth.
 Never immerse the device in water.
 Never use aggressive cleaning agents or sol-
vents.
14 Warranty
The Stanley TLM has a two-year warranty.
For further information on this, contact your
dealer.
Subject to change (drawings, descriptions and
technical data).
Temperature range:
- Storage
- Operation
-25 °C to 70 °C
-13 °F to 158 °F
0 °C to 40 °C
32 °F to 104 °F
Warning
Possible disturbance of other devices
(e.g. safety equipment, medical equipment)
due to electromagnetic radiation!
 Observe the safety instructions of the respective
devices.
Warning
Bodily harm due to laser beam!
 Do not look directly into the laser beam.
 Do not look directliy into the laser beam with
optical appliances (such as binoculars, teles-
copes).
Stanley TLM 130i.book Page 13 Tuesday, February 5, 2008 5:00 PM
To Next Page
Loading...
Need help?
General
