Need help?Do you have a question about the Star Micronics futurePRNT TSP100 and is the answer not in the manual?
Affix ferrite core, pass cable through support, then connect USB interface cable to the printer.
Connect a peripheral unit using a modular plug via the peripheral drive connector on the rear panel.
Open printer cover, set roll paper, pull edge, and close cover securely.
Connect the USB interface cable to a USB port of your PC.
Details on automatically recoverable, non-recoverable, paper cut, and paper detection errors.
Steps to safely remove jammed paper, including opening the cover and checking ERROR LED.
Procedure to release a locked auto cutter by turning power OFF and using a screwdriver.
General| Print Method | Direct thermal |
|---|---|
| Resolution | 203 dpi |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
| Print Speed | Up to 250 mm/sec |
| Paper Width | 80 mm |
| Interface | USB, Ethernet |
| Dimensions | 142 x 204 x 132 mm |
| Operating Temperature | 5°C to 35°C (41°F to 95°F) |
| Humidity | 10% to 90% RH (non-condensing) |
| Paper Thickness | 0.085 mm |
| Weight | 1.7 kg (3.75 lbs) |
To Next Page