Star Micronics IFBD-HE07 - IP Address Setting

IFBD-HE0708 BE07 User’s Manual
3-2
3.1.1 IP Address Setting
Thisproducthasastatic(xedcondition)anddynamic(DHCP/BOOTP,RARP,andARP/Ping)IPaddress.Itispossibletospecifya
sub-net mask and default gateway with static and DHCP, BOOTP.
In the default settings, static is invalid and dynamic is valid.
The following pages describe how to acquire an IP address for each. See section 3.1.1.5 Address Acquisition Process Transition for
details on each protocol transition state.
This product allows you to check the current IP parameter information while operating by a self-print when turning the power on.
This is output in the following format after running a self-print. See section 3.2.3 Self-print for details on running a self print.
* Protocol: The IP address acquisition protocol below is shown in the parentheses of the operating IP address line.
(Static): Static (Fixed address)
(DHCP): Gets from DHCP server
(BOOTP): Gets from BOOTP server
(RARP): Gets from RARP server
(Didn’t obtain): No IP address was acquired.
YoucanndtheMACaddresstouseinthissectionbyusingoneofthefollowingmethods.
1. Execute a printer self-print (see section 3.2.5).
2.Checktherst12charactersinthebarcodelabelafxedtotheI/Fcardconnector.
Example for when the MAC address is 00:11:62:11:11:11