Star Micronics IFBD-HE07 - Settings and Display Items; IP Parameter Settings; System Settings

IFBD-HE0708 BE07 User’s Manual
3-41
3.3 Settings/Display Items
The following describes the types of information that can be set and displayed by HTTP (WEB), TELNET, FTP.
3.3.1. IP Parameter Settings
ThefollowingtableshowstheStatic(xedaddress)andDynamic(dynamicaddressacquisition)itemsoftheIPaddressthatcanbe
stored in the non-volatile memory.
Category Setting Items Input Range Initial Value (Factory Default)
Static IP Address 0.0.0.0 - 255.255.255.254 0.0.0.0
Subnet Mask 0.0.0.0 - 255.255.255.255 0.0.0.0
Default Gateway 0.0.0.0 - 255.255.255.255 0.0.0.0
Dynamic DHCP, BOOTP ENABLE/DISABLE ENABLE
RARP ENABLE/DISABLE ENABLE
Note: If setting Static to anything other than 0.0.0.0, set all Dynamic to DISABLE.
If setting Dynamic to ENABLE, set all Static to 0.0.0.0.
3.3.2. System Settings
The following shows the NIC system setting items.
These settings are stored in the non-volatile memory on the product’s card.
Setting Items Input Range Initial Value (Factory Default)
“user” Login Password (Note 1) • 1-31 characters
• ASCII characters
• Upper case/lower case sensitive
“guest”
“root” Login Password • 1-31 characters
• ASCII characters
• Upper case/lower case sensitive
“public”
Web Page Refresh Interval Time (sec.) 1 - 300 5
9100 Multi Session ENABLE/DISABLE DISABLE (Note 2)
9100 Data Timeout (Sec.) 0, 30, 40, 60, 120, 180, 360 0
TCP Keep-Alive ENABLE/DISABLE DISABLE
FTP Server ENABLE/DISABLE ENABLE
Disconnect Message ENABLE/DISABLE DISABLE
(Warning data Note 3) Line1
Line2
Line3
Line4
Default Message (Note 4)
TCP Port80 (Note 5) ENABLE/DISABLE ENABLE
Subnet Mask(BOOTP) (Note 6) HE05 Emulation / HE07 Emulation HE05 Emulation
TCP SYN Timeout (Sec.) (Note 7)
1 ～ 300
104
TCP SYN Interval (Sec.) (Note 7)
1 ～ 300
2
#22222 FS 3 Command (Note 8) ENABLE/DISABLE DISABLE
Note 1: The “user” login password is displayed with the default value (“guest”), but if changed
tootherthanthedefault,itiscamouagedwith“********.”
Note 2: The factory default settings for 9100 Multi-session are different for the old (IFBD-HE05/06/BE05) and new
products (IFBD-HE07/08/BE07).
IFBD-HE05/06/BE05 (old product): ENABLE
IFBD-HE07/08/BE07 (this product): DISABLE
Note 3: Warning data registration is done only on HTTP (Web).
Note 4: When Disconnect Message = ENABLE, press Default Message to display the next data in Line 1 – Line 4
elds.
  Line1:******************************
Line 2: NO HOST CONNECTION
  Line3:******************************
Line 4:
Note 5: The TCP Port80 setting is only available for Telnet. Supported by Ver 2.3.0 and later.
Note 6: This setting is only available for Telnet. Supported by Ver 3.0.0 and later.