Star Micronics IFBD-HE07 - F;W Update via FTP

IFBD-HE0708 BE07 User’s Manual
3-23
3.1.8.1. FTP Printing
When writing data to the \Ip\ directory, it is transferred to the printer as print data.
3.1.8.2. NIC Setting
LogintotheFTPserverfromanFTPclienttoviewthesettingsbyreadingthesettingleinthe\net_cong\directory.Also,by
uploadingthesettingletothesamedirectory,youcanstorethesettingsinthenon-volatilememory.
TheextensionsoflenamesuploadedfromtheFTPclientarechangedto“$$$”priortowritingtoNVRAM,andthelesaresaved
asmid-wayles.Whenupdatingissuccessful,themid-waylesaredeleted,butiftheformatofthesettingcontentsisincorrector
thewritingtothenon-volatilememoryiserroneousandthewritingfails,theleswillremainwithoutbeingdeleted(extension“$$$”)
Also,ifwritingendsnormally,theprinterwillautomaticallybereset.Ifthe“CongurationPrint”itemis“Enable”theresetwillbe
applied when the settings print is ended.
Setting Example: Example of F/W Ver. 5.0.0, Star WebPRNT model (netconf.ini)
The loaded NIC MAC information is used
for the MAC Address item, but when
uploaded, the MAC information field is
ignored. Therefore, when you use a
loaded setting file to upload to NIC, you
do not need to change this field.
<< IFBD-HE07X/08X Information >>
MAC Addr :00:11:62:12:34:56
Configuration Print :ENABLE
<< IFBD-HE07/08 Information >>
MAC Addr :00:11:62:00:01:d8
Configuration Print :ENABLE
<< IP Parameters -NVRAM- >>
IP Address :192.168.10.1
Subnet Mask :255.255.255.0
Default Gateway :192.168.10.254
DHCP/BOOTP :DISABLE
RARP :DISABLE
<< System Configuration >>
"user" Login Password :"guest"
"root" Login Password :"********"
Web Refresh Time (Sec.) :5
9100 Multi Session :DISABLE
9100 Data Timeout (Sec.) :0
TCP Keep-Alive :DISABLE
FTP :ENABLE
Disconnect Message :ENABLE
TCP Port80 :ENABLE
Subnet Mask (BOOTP) :HE05 Emulation
TCP SYN Timeout(Sec.) :104
TCP SYN Interval(Sec.) :2
#22222 FS 3 Command :DISABLE
<< Web Print >>
TCP Port Number :80
<< SNMP >>
Authentic Community :"******"
Trap Community :"public"
Trap Address(IP) :0.0.0.0
SysContact :"1234"
SysName :""
SysLocation :""
EnableAuthenTrap :2
<< SSL/TLS >>
SSL/TLS :"DISABLE
TCP Port :443
Certificate :Self-Signed
Self-Signed Command :Not Exist
CA-Signed Certificate :Not Exist
When you specify Enable for the
Configuration Print item, you can print the
settings to verify that they have been
loaded to the non-volatile memory.
The factory default setting for 9100
Multi-session is different from the old product.
Factory Default Settings
IFBD-HE05/06/BE05 (old product): ENABLE
IFBD-HE07/08/BE07 (this product): DISABLE
The Web Print setting items are for
the Star WebPRNT model only.
The SNMP setting items are for
F/W Ver. 5.0.0 or later only.