Star-net FT5X - 4.4 Telephone Keypad Configuration Commands

FT5X User Guide
4.4 Telephone Keypad Configuration Commands
User may enter commands by using telephone keypad of a telephone connected to the
Phone socket on the back panel of the unit as follows:
1. Lift Receiver
2. Enter Command – a confirmation tone will then be heard
3. Replace Receiver
4.4.1 System Configuration
1. Set work mode
Command：#*1*working mode#
Description：Set the work mode of terminal，Working mode = 0 is voice mode；1is
voice/fax mode；2 is PBX relay mode；3 is PBX extension access mode
2. Set dial mode
command：#*333*n#
Description：set the terminal dialing mode, n=0 is audio dial mode; n=1 is pulse dial
mode.
3. Set system date
Command：#*20*y*m*d#
Description：Set the system date, y means（00～99）；m means month（0～12）；d
means day（0～31）
4. Set system time
Command：#*21*h*m*s#
Description：Set the system time of the device, h means hour（0～24）；m means
minute（0～59）；s means second（0～59）.
5. Set auto-dialing delay
Command：#*3*seconds#
Description：Set up dialing overtime and auto sending-out time upon completely entry
of numbers, default setting 3 seconds.
<seconds> Set point range 1-20 sec
6. Set external line flash key delay
Command：#*4*<flashDelay>#
Description：Set external line flash key delay, default, 700ms delay
<delay> 0~2000 ms
7. Set GSM output voice volume
Command：#*53*volume#
Description：Set GSM output voice volume，volume （0～4）.
8. Set overtime of Button R
Command：#*85*n#
Description：Set overtime of Button R, This feature is only available in the SIM card
used by the open call waiting function effectively. Default, 2 seconds
<n> 1~5 seconds
23/31