FT5X User Guide
9. Set FAX and Voice Ring both
Command：#*68*n#
Description：Set FAX and Voice Ring both，when n is 0 means off， and 1 means o.
This function is NO effective on the hardware board version 2.0.
10. Minute Prompt
Command：#*110*n#
Description：n=1，the device will send a prompt tone per one minute during user’s
conversation. n=0，Off this function.
4.4.2 Fax mode configuration
1. Set fax receive mode
Command：#*63*n#
Description：n=0 fax receiving mode is Synchronization; n=1 fax receiving mode is
Asynchronous. Default n=0.
2. Set fax send mode
Command：#*64*n#
Description：n=0 fax sending mode is Synchronization; n=1 fax sending mode is
Asynchronous. Default n=0.
4.4.3 Call Diverts
1. Set the divert number from FXO to GSM
Command ：#*71*Number#
Description：Set the divert number from FXO to GSM，Number is the number which
dialed from GSM port.
2. Set the appointed incoming call number by FXO
Command：#*72*number#
Description：Set the appointed incoming call number by FXO. When the incoming call
number is the appointed number on FXO port the device will looks this incoming call
as special call.
3. Clear the incoming call number appointed by FXO
Command：#*73#
Description: Clear the appointed incoming call that has been set.
4. Set no answer delay for FXO
Command：#*74*time#
Description：Set no answer delay time for FXO
5. Set the FXO call diversion type
Command：#*75*n#
Description：Set the FXO call diversion type (0=divert always；1=divert when no
answer; 2=do not divert)
6. Set the call divert switch from GSM to FXO
Command：#*76*n#
Description：Set the call divert switch from GSM to FXO(0=no from FXO ；1=from
FXO)
24/31
To Next Page
Loading...