FT5X User Guide
7. Set the call divert number from GSM to FXO
Command：#*77*number#
Description： Set the call diverts number from GSM to FXO. When the function of call
diversion from GSM to FXO is on, GSM dial this Number from FXO port.
4.4.4 Detect the caller ID identification function standard
1. Detect the standard of supporting caller ID identification
Command：#*99#
Description: Detect the standard of supporting caller ID identification. After completing
this command, the user should hang up the phone immediately. If the standard of
displaying caller ID identification is complied with local standard, then the user’s CLI
display will show “0123456789”. If the device can not display this character string, the
user will need to change the current standard of caller ID identification by command
“#*81*n#”.
2. Set the device to support the three different standards of caller ID identification
Command：#*81*n#
Description: Set the device to support the three different standards of caller ID
identification.
(0=Off；1= ETSI DTMF；2= ETSI V.23；3= Bellcore)（Default value is 3）
3. Set keyboard command for transmitting caller ID during calling
Command：#*82*n#
Description: Set keyboard command for whether or no transmitting caller ID during
calling (0=No transmit；1= Transmit).
4.4.5 Set Serial port Mode
1． Set serial port mode
Command：#*83*n#
Description: Set serial port mode (0=Off；1=CLI； 2=MODEM).
4.4.6 SIM Card settings
1． Input PIN code
Command：#*86*n#
Description: Input PIN code，n is the PIN code which input by user
2． Modify PIN code
Command：#*88*oldpin*new*newV#
Description: Modify PIN code. The “Oldpin” is old PIN code，the “New” is new PIN
code，the “NewV” is confirm new PIN code.
3． Input PUK code
Command：#*89*PUK*PIN#
Description: Input PUK code，PUK is input by user，PIN is new PIN code input by user
4． Set PIN code function
Command：#*90*n*pin#
Description: Set PIN code function (n=0 Disable PIN function；n=1 Enable PIN
function)
25/31
To Next Page
Loading...