Star Trac Pro Stepper - Maintenance Mode

OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Manager Mode.
NOTE: To exit Manager Mode without saving any values or settings, press the QUICK START key.
The items that you may display and change with the previous keys are:
MAINTENANCE MODE
Your Service Representative may need to check accumulated data about the past usage of your STAR TRAC PRO STEPPER,
test its display controls, or investigate error messages. For these reasons, your Stepper is equipped with a Maintenance Mode. The
Maintenance Mode includes all of the items available through Manager Mode, plus additional items for Service and Diagnostic
use. To enter Maintenance Mode:
1. Press and hold the
,
and keys together.
2. A beep will sound and “MAINTENANCE MODE” will display momentarily in the Information Window.
3. Release all keys. “SERIAL NO #####” will display in the Information Window.
The following keys are available in MAINTENANCE MODE:
Upper and Lower Data Information Window S
CROLL Keys: Display the next and previous parameters,
respectively. Keys will repeat if held.
Increase and Decrease LEVEL Keys: Adjust the value of the displayed parameter up and down, respectively,
in increments of 1 unit. These keys do not save the new value - see OK Key below.
Numeric Keypad: Allows you to enter specific values for numeric parameters. These keys do not save the new
value - see OK Key below.
OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Maintenance Mode.
NOTE: To exit Maintenance Mode without saving any values or settings, press the QUICK START key.
The items that you may display and change with the previous keys are:
STAR TRAC PRO STEPPER O WNER ’ S M ANUAL 27
Lowest Highest Default
Item Value Value Value Meaning
Serial No 0 65535 0 Serial number (set by factory)
Date 01/00 12/99 01/05 Manufacture date for the Stepper (set by factory)
Display Vers 1 01.00 99.99 N/A Display panel software version (set by factory)
Display Vers 2 01.00 99.99 N/A Display panel software version (set by factory)
LCB Vers 01.00 99.99 N/A Display panel software version (set by factory)
Units English Metric English English = units of pounds, feet,
Metric = units of kilograms, meters
Time 5 99 99 Maximum time in minutes allowed for program, excluding cool-down.
Weight 1 (Lb) 350 (Lb) 155 lbs Default (to user), typical weight in lb (UNITS=English), or kg
1 (KG) 158 (KG) 70 (KG) (UNITS=Metric).
Language N/A N/A ENGL Language is English (ENGL), Dutch (DUTC), French (FREN), German
(GERM), Portuguese (PORT), Spanish (SPAN), Swedish (SWED), Italian
(ITAL) or Katakana (KATA).