Star PowerFlush Optima S1201 - Exposed Pump Unit Installation; Positioning and Initial Connection

10
1. Position the grinder/tank unit a minimum of 1/8" from
the wall with the inlet facing forward. Attach the rubber
coupling to the inlet using the worm drive clamp provided.
IL1740
Inlet
Wall
Grinder
Pump Unit
1/8 in.
Minimum
Rubber
Coupling
Clamp
3. Connect the water supply line to the ballcock shank
that extends below the toilet tank by tightening the
plastic adapter with rubber washer over the end of the
ballcock shank.
CAUTION: Do not overtighten. Ballcock shank may
split and void the warranty.
WATER SUPPLY HOOKUP
Ballcock
Toilet
Tank
Rubber Washer
Plastic Adapter
IL1739
2. Place the toilet in front of grinder/tank unit; aligning the
discharge of the toilet with the inlet of the grinder/tank unit.
Check to be sure that the rubber coupling will bridge the
gap adequately for final installation. The toilet tank should
be a minimum of 1/2 in. from the wall.
CAUTION: Do not connect rubber coupling to toilet at this
time.
IL1741
Grinder
Unit
Inlet
Toilet Discharge
1/2 in. Minimum
Wall
3
1
2
EXPOSED PUMP UNIT INSTALLATION