BASIC OPERATION
14 15
D. Direction Selection
The rocker switch on the left side of the control panel in the center of the
dash is the drive selector. This is a three position switch. Confirmation of
your selection can be seen in the digital display with one of the
following symbols:
1. Drive
The direction selector must be placed in “Drive” in order to move in a
forward direction. Although there is an electronic failsafe to prevent
direction changes while in motion, it is heavily discouraged to do so.
Make sure your vehicle comes to a complete stop before selecting a
different direction.
2. Neutral
The direction selector should be positioned in Neutral when not
operating the vehicle.
3. Reverse
When you wish to move in reverse, the reverse switch is also located
on the control panel. When engaged, the rocker switch should display
“R” in the digital display panel, to the right of the speedometer. For those
units equipped with optional rear view camera, the entire screen will
show camera view.
D Drive
N Neutral
R Reverse
To Next Page
Loading...