LIFTING THE VEHICLE
70 71
C. LIFTING THE VEHICLE
If maintenance that requires lifting the vehicle is needed, follow the
specific guidelines to ensure a safe, stable environment is established.
Any common floor jack can be used to lift the vehicle, providing the
proper jack points are utilized to prevent damage or injury. If lifting the
front, locate the jack pad under the front cross beam on the frame in
between the lower control arms. DO NOT lift vehicle with any other
part of the chassis.
If lifting the rear, use only the differential housing as the jack point.
Ensure the front tires are secured using something large and heavy
preventing the front wheels from rolling. Because the housing is off
center, the vehicle may lean towards the driver’s side until jack stands
can be properly placed.
Jack stands can be placed anywhere along the frame rail but is
recommended to follow the locations shown in the image.
WARNING: Do not perform any work until jack stands are in place and
the vehicle is secure. Once positioned, it is advisable to jiggle the chassis
to make sure the vehicle is secure on the stands.
(see diagram for lifting vehicle on page 71)
To Next Page
Loading...