- 13 -
2. Setup
2.1 Battery Pack
2.1.1 Inserting into the Printer or the Battery Holder
1. Make sure that the printer has been turned o before you insert or remove the battery pack.
2. Insert the battery pack into the back of the printer as in the gure shown below, following the di-
rection of the arrow.
3. To remove the battery back, pull back the hook, and use the opposite procedure from the one you
used to insert the battery pack.
4. The battery pack install into External Battery Cradle.
Insert the battery pack in the direction of the arrow.
Hook
Push the battery pack until
the hock clicks into place.
To Next Page
Loading...
