Star SM-T300I Series - General Specifications

- 35 -
5. General Specications
Item Specications
Printing method Direct line thermal printing
Characters per line Maximum 64 cpl
Character size
Alphanumeric characters: 9 X 24 dots, 12 X 24 dots, and 9 X 17 dots
Japanese characters: 24 X 24 dots
Character types
Alphanumeric characters, expanded graphic characters, JIS Level-1 Kanji Set,
JIS Level-2 Kanji Set, and special characters
Dot density 203 dpi (8 dots/mm)
Printing width 72mm, 576 dots
Print speed 80 mm/s (max)
Interface
Bluetooth
Bluetooth Spec. Bluetooth 3.0 / Class 2 (10 m)
Frequency Range 2.4 GHz ISM BAND
Support Prole SPP (Serial Port Prole)
RS-232C
Emulation ESC/POS, FIrmware version 3.1 or later : StarPRNT
Roll paper Thermal roll paper (80 mm wide with a diameter of Ф50 mm)
Barcode
1D: JAN, EAN, UPC, ITF, Code39, Code93, Code128, CODABAR(NW-7),
GS1 Barcode(StarPRNT only)
2D: PDF417, QR Code, DATA Matrix(ESC/POS only), GS1 2Dcode(StarPRNT only),
GS1 Conposite(StarPRNT only)
Receive buer size 1M bytes
*1)
MSR
SM-T300i : Not Supported MSR
SM-T301i : ISO 7810 / 7811 / 7812 1st and 2nd Track Reading
LCD 128×32 Dots FSTN (Blue LED Backlight)
Battery pack Rechargeable 7.4V DC 1800mAh
Battery operating time
Approximately 26 hour printing (12 receipts per hour)
Approximately 31 hour prnting (12 receipts per hour / Sleep setting after 1 minute)
Battery charger
Input: 100 to 250 V AC, 50 to 60 Hz
Output:8.4 VDC/0.8 A, Time required for full charge: 4 h
Environmental Requirements
During charging Temperature : 0
o
C to +40
o
C
During operation
*2 )
Temperature : -10
o
C to +50
o
C
Humidity : 30% to 80% (No condensation)
During storage
Printer
Temperature : -20
o
C to +70
o
C (1month)
Humidity : 10% to 90% (No condensation)
Batterypack
Temperature : -20
o
C to +50
o
C (1month)
-20
o
C to +40
o
C (3month)
-20
o
C to +20
o
C (1year)
Print head life Approximately 50 km
Drop resistance 1.5 m / 1.2 m (Model with Card Reader) *3)
Dust protected, Splash proof IP54 Certied *3)
*1)
If the quantity of data which is printed at once is more than 1M byte on Bluetooth communication, it would cause the
buer to overow and the data to get damaged.
*2) Under 0°C, please change Density mode and Quality mode of the memory switch settings to both “High”.
If you want to print a delicate pattern like Barcode printing, please use the printer over 0°C.
*3) Our test procedure, Not guarantee.