Installation person must be related industry or related experience of technical
personnel.
You must be carefully read this manual before installation.
To confirm the selected power supply is consistent with his requirement
specification.
You are strictly been prohibited under the conditions of electricity installation or
plug or unplug.
Installation position should as far as possible away from heat source.
Controller enclosure must be good grounding, or influence the controller in
work.
The be cutting steel plate must be in good grounding and keep good
connection with controller shell, to ensure the accuracy of the height control.
Please careful carry away, and please do not intense collision, vibration, in
order to avoid damage to the product.
Please don not do something without authorization to open cutting torch height
controller or change its internal structure, to prevent the accident or failure.
Note: the controller casing and cut steel without good grounding, height control
will not be able to work properly.
2.Overview
2.1 Technical features
SF-HC25G plasma cutting torch height controller is after many years of
practice and several generations of related products into play.
This product adopts the 32-bit arm as the core, two groups of three digital tube
display, adopts digital control mode. Do not contain linear adjustment device
internal, greatly improving the stability.
To Next Page
Loading...
