®
QuickTIPS
SURFLINK MEDIA: SETUP
PRODUCT AVAILABILITY: Z Series, 3 Series wireless, Xino wireless, Wi Series
ENABLING SURFLINK MEDIA IN INSPIRE
1. Launch Inspire 2014.3 or higher.
2. Connect and detect hearing aids to the fitting computer via the
appropriate programming accessories. Refer to the Boots and
Cables Programming Guide available via Inspire Online for additional
information regarding connecting the hearing aids.
3. Select New Session on the Get Started Screen and select Start.
NOTE: Auto Path will default to launching automatically for hearing
aids that have not been previous read by Inspire.
4. Select Accessories on the left navigation bar.
5. Select SurfLink Media under SurfLink Accessories.
6. Select which memories will automatically accept a streamed signal
by selecting the boxes adjacent to the memory name under Media
Streaming AND select Hearing Aid Microphone Setting While
Streaming for each memory if desired.
7. If using Advanced SurfLink Remote Control or SurfLink Mobile along
with SurfLink Media:
» Advanced SurfLink Remote:
-Enter SurfLink Remote Address in Configure SurfLink
Remote Control and select Sync.
-Ensure the Favorite Button is set to Stop/Start Audio Stream.
» SurfLink Mobile:
-Ensure the Favorite Button is set to Stop/Start Audio.
NOTE: Stream Boost defaults ON (Stream Boost is only available
for the Z Series products). Deselect Stream Boost to disable.
Configure Streaming Behavior
Streamboost is available in Z
Series products to deliver an
automatic and enhanced sound
quality experience to the patient
any time a streamed media input
is detected.
Enable SurfLink Media
To Next Page
Need help?
General
