Programming
6
[B.R.I.G.H. .8.O.] it indicates that the end has been reached in that direction, or that modification is not
allowed.
3.2 Access to USER Menu (User)
To access the USER menu, go through the following stages:
Note: some messages may not appear because the functions are not enabled, and some messages which are
not described may appear, if enabled.
Stage action display notes
1 Switch off the control unit [ ]
2 Switch on the control unit, keeping
the _M_ key pressed until the
message "OK MENU" appears on
the display s(after several seconds).
[ STARTEC]
[ R.S.260 ]
[VER 1.18 ]
[USR MENU]
[OK MENU]
- Manufacturer’s name
- Model of machine
- Program version
- User menu
- Access enabled
When the DOWN ARROW _v_ is pressed several times, the following messages are displayed in turn:
When the UP ARROW _^_ is pressed several times, the same messages are displayed in reverse order.
3.3 SECTORS Programming
Display the SECTORS options by repeatedly pressing the DOWN ARROW _v_ key.
DISPLAY DESCRIPTION
[SECTORS]
Press _>_ key to access a sub menu with the following SECTORS options
[NumSET 1] This entry establishes the number of sectors that require irrigation.
Number of programmable sectors:
0 = with no supplementary features
1 = with Maximum Running Time and Initial Holding Time
2-8= with SECTORS, Maximum Running Time and Initial Holding Time
Press _>_ to access length and speed parameters of the various sectors.
(the data in this table are all modifiable and can be scrolled either up or down):
[m 1 100.0]
This entry specifies the length of sector 1. Press _>_ to display
another entry.
[m/h1 30.0] This entry specifies the speed of sector 1, m/h.
[m 2 100.0]
This entry specifies the length of sector 2. Press _>_ to display
another entry.
[m/h2 30.0] This entry specifies the speed of sector 2, m/h.
[m x 100.0]
This entry specifies the length of sector x. Press _>_ to display
another entry.
[m/hx 30.0] This entry specifies the speed of sector x, m/h.
[m 8 100.0]
This entry specifies the length of sector 8. Press _>_ to display
another entry.
[m/h8 30.0] This entry specifies the speed of sector 8, m/h.
Saving the changes
To save the changes which you have made to the Rain Star 260’s memory:
STAGE ACTION DISPLAY NOTE
1 Press the START _START _ key.
Press the START _START _ key again
[CHN SAVE
[SAVES CH]
Requests SAVE CHaNges
SAVES the CHanges
Once this operation is completed, the Rain Star 260 exits from the Menu and goes to the stage of
Cancelling changes
To cancel the changes which you have made:
STAGE ACTION DISPLAY NOTE
To Next Page
Loading...
Need help?
General
