Starway modena - Receive and Addressing; User Mode Selection; Advanced Function Settings

Page 48
RECEIVE
Address Mode :
To facilitate the design of LED arrays with entry-level DMX lighting desk,
it is possible to address the Modena in the classic way (all channels are addressed contiguously).
Or to select a rst address for the general parameters of the projector and a second for the matrix of LEDs.
Set Address :
Conguration of the Modena DMX address
USER MODE
User Mode :
Selection of the DMX mode of the Modena between the different modes such as:
- Basic 8B - 15 channels DMX - Leds Mode 8 Bits
- Basic 16B - 19 channels DMX - Leds Mode 16 Bits
- Standard 8B - 21 channels DMX - Leds Mode 8 Bits
- Standard 16B - 25 channels DMX - Leds Mode 16 Bits
- Pixel 8B - 41 channels DMX - Leds pixel/pixels 8 Bits
- Pixel 16B - 9 channels DMX - Leds pixel/pixels 16 Bits
- User A - User mode 1
- User B - User mode 2
- User C - User mode 3
Edit A ; Edit B ; Edit C
In this sub-menu it is possible to create 3 channel assignments at the discretion of the user. In each “Edit A; Edit B and
Edit C “it is possible to select the maximum number of channels, and to change the order of the DMX channels.
FUNCTION
Status
In this sub-menu it is possible to modify the behavior of the Modena.
No DMX Mode : Modication of the Modena reaction during DMX signal loss :
- Hold : Hold the last DMX values received
- Auto : The Modena switches to Auto mode
- Black : The Modena goes into «Stand By» mode
P Reverse : ON/OFF - Pan inversion
T Reverse : ON/OFF - Tilt inversion
PAN degree : 630° or 540° - Selection of the maximum angle of PAN
Feedback : ON/OFF - Activation or Deactivation of motors feedback
Move Speed : Selection of movement speed between 1 and 4
1 - faster to 4 - slower
Hibernation
If there is no signal, the projector will go into standby mode until the signal returns:
OFF - 01 Min to 99 Min - Selection of the Modena hibernation mode.
OFF by default or from 1 minute to 99 minutes before switching to hibernation mode.
Fixture ID
Sub-menu allowing the modication of the receiving DMX universe (ArtNet and sACN) as well as Modena’s IP address and
the subnet mask.
Universe: 0-255 - Selection of the DMX receiving universe
UnitIPAddr: xxx.xxx.xxx.xxx - Selection of the Modena IP address
MaskAddr: xxx.xxx.xxx.xxx - Selection of the Modena subnet mask
Protocol Set
Sub-menu allowing the selection of the Modena network protocol:
Artnet (by default) or sACN
KlingNet
Submenu allowing KlingNet protocol activation or not:
Enable (default) or Disable