Starway modena - Page 49

Page 49
Net Switch
Sub-menu allowing the activation or deactivation of Modena’s Ethernet switch
Dim Speed
Sub-menu allowing the dimmer’s smoothing choice between Standard (default), Stage, TV, Architectural or Theater..
Temp C°/F°
Sub-menu for selecting the Celsius (default) or Fahrenheit system, for displaying the temperature.
Dim Curve
Submenu allowing the selection of the dimmer curve between Linear (default), Square, Exp, Log and S-Curve.
Frequen
Sub-menu allowing the selection of the refresh rate of the LED to avoid a possible «icking» during video lming. Change-
able value between 900Hz (default) and 25Khz.
Fan Set - Head Fan
Sub-menu for selecting the head fan behavior between Auto (default) and Low or High.
LCD Set
Sub-menu allowing to select the behavior of Modena’s display.
Backlight - 02m to 60m - Selection of the display backlight retention time (without menu manipulation) from 2
minutes to 60 minutes. Time set to 5 minutes by default.
Flip Display - ON / OFF - Reversal of the display direction
KeyLock - ON / OFF - Locking of the Modena’s buttons.
DispFlash - ON / OFF - Activation or not of the display ash when the Modena does not receive a DMX signal.
.
Disp.Set
Chan.Value - continuous display of DMX values of all channels.
Slave Set - Selection of Modena slave mode to “offset” Modena when using Master / Slave mode - between
Slave 1, Slave2 and Slave 3.
Auto Prog - Master / Slave mode selection:
In MASTER mode, master Modena transmits the information to all Modena
connected using a DMX cable and where Slave mode has been activated
in the “Slave Set” submenu
In ALONE mode Modena does not transmit information and executes
its AUTO mode individually.
DFSE - ON/OFF - Reloading the Modena default settings.
USB Update - ON/OFF - Modena rmware update.