Nombre del Producto modelo
39
Installation
Please, note that the security regulations for domestic electric appliances and other related equipment must be observed in all
installation works.
Regarding legal requirements and standards to be met, please, write down the following points to ensure the utmost security
and reliability of your system.
3.1 Before beginning the system installation, thoughtfully assess all potential risks involved in the door automation.
3.2 Check that the power supply values are the same provided in these instructions.
3.3 Check and protect the system with all the right electrical safety measures for voltage and grounding.
Keep in mind that the operator is powered with 230V and there are electric shock and fire hazards.
3.4 Be careful not to damage the electronic assembly parts, do not handle them if not necessary.
3.5 Make sure you have all the necessary and appropriate materials for the installation.
3.6 Read all the instructions before attempting to install the operator, and make sure you understand them.
3.7 Before beginning the system installation, thoughtfully assess all the potential risks involved in the door automation. Verify
the good conditions of the door and the mechanisms to be automated. Observe the security margins and minimum distances.
3.8 Examine carefully the security devices that must be installed and their proper mounting place. Connect to the mains an all
pole breaker with a contact aperture of 3mm or grater. We recommend an all pole thermal-magnetic breaker of 6Amp.
3.9 Once all risks have been assessed, install the operator and security devices: safety contact strips, stop button or
photocells.
Note: Regarding additional security measures, we strongly recommend the use of photocells in all installations.
3.10 During operator installation works, strictly follow all the instructions in this manual; in case you do not understand any
point or procedure included in this manual, do not hesitate to call our technical department.
To Next Page
Loading...