Steamfast NOMAD - SAFE USE WARNINGS AND GUIDELINES; Supervision and Unattended Operation; Handling Hot Surfaces and Steam; Water Type and Cleaning Agent Restrictions

ENGLISH
|
3
dropped or damaged. To reduce the risk of electric shock, do not disassemble or
attempt to repair the appliance, take it to a qualied person for examination and
repair. Incorrect reassembly or repair could cause a risk of re, electric shock, or
injury to persons when the appliance is used.
- To reduce the likelihood of circuit overload, do not operate another high wattage
appliance on the same circuit.
- If an extension cord is absolutely necessary, a 15 ampere rated cord should be
used. Cords rated for less amperage may overheat. Care should be taken to
arrange the cord so that the cord cannot be pulled or tripped over.
- This appliance has a polarized plug (one blade is wider than the other.) To reduce
the risk of electrical shock, this plug is intended to t in a polarized outlet only one
way. If the plug does not t fully in the outlet, reverse the plug. If it still does not
t, contact a qualied electrican. Do not attempt to defeat this safety feature.
- A loose t between wall outlet (receptacle) and plug may cause overheating and
distortion of the plug. Discontinue use of the product in this outlet. Contact a
qualied electrician to replace loose or worn outlets.
- Wrap cord with supplied “hook and loop” fastener when storing.
SAFE USE WARNING – To reduce risk of re, electrical shock and injury to
persons, observe the following:
- Close supervision is required for any appliance used by or near children. Do not
leave the appliance unattended while it is connected.
- Use caution when handling this steam unit. Burns could occur from touching hot
metal parts, hot water, or steam. Use special care to avoid contact with hot water.
- To reduce the risk of contact with hot water emitting from steam vents, check
appliance before each use by holding it away from body and operating Steam
Button. Do not operate unit if steam vents are blocked.
- When lling unit, only distilled water should be used - other cleaning agents could
damage unit or cause injury.
- Do not attempt to use unit without properly lling Water Tank. To avoid burns
from escaping steam when relling tank: Press and hold Steam Button to release
all remaining steam pressure and always allow unit to cool before relling.
- Use caution when carrying unit up stairs or over obstacles, or when using unit on or
near an uneven surface.
- Burns can occur from touching hot plastic parts, hot water, or steam. Do not
touch Steam Nozzle or attempt to connect any accessories while unit is in use. Use
caution when you turn unit upside-down - there may be hot water inside.
- When steaming any fabric for the rst time, it is recommended that you consult the
manufacturer’s guidelines for the material being steamed. For items in question,
test on an inconspicuous area before proceeding.