ENGLISH
|
9
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE & SOLUTION
Unit fails to heat up.
Steam Status Light DOES
NOT illuminate.
Unit is not plugged in. Plug power cord into electrical outlet.
The ON / OFF Button is pressed Off. Make sure the ON / OFF Button is
pressed to turn the unit On and Steam Status Light is illuminated.
Household circuit breaker / ground fault interrupter has tripped or blown a
fuse. Reset circuit breaker / ground fault interrupter, or replace fuse. For as-
sistance, contact a licensed electrician.
Unit is damaged or otherwise in need of repair. Immediately cease usage
and unplug. Contact Consumer Service for assistance.
Unit heats up, but fails to
steam.
Steam Status Light
DOES
illuminate.
NOTE: Always allow suf-
cient time for unit to heat
up before pressing Steam
Button.
Water tank is empty. Refer to FILLING WATER TANK procedure on Page 6.
Mineral build-up in unit. Refer to STORAGE & CARE section on Page 8 for
details.
Unit is still heating up. Wait to use the Steam Button until the Steam Status
Light has turned green.
Steam output is weak or
intermittent.
Mineral build-up in unit. Refer to STORAGE & CARE section on Page 8 for
details.
Unit is spitting water with
residue.
Use only with distilled water.
Mineral build-up in unit. Refer to STORAGE & CARE section on Page 8 for
details.
To Next Page
Loading...
