Steamfast NOMAD - HOW TO OPERATE YOUR STEAMER; Filling the Water Tank Correctly; Cooling Unit Before Refilling; Water Tank Replacement and Sealing

6
|
ENGLISH
HOW TO USE
FILLING TANK WITH WATER
1. Turn OFF ( ) and unplug unit from power source.
2. Place steamer on its side on a at, heat resistant, level surface.
CAUTION: If unit has been in use, allow to cool (5 minutes for minimum cooling before
removing Water Tank and adding water).
3. Remove Water Tank by pulling the Water Tank downwards away from the unit, see Figure 1.
FIGURE 1
4. Remove rubber cap from top of Water Tank and ll with distilled water from a bottle or cup.
Replace rubber cap on top of the Water Tank. Do not overll Water Tank.
NOTE: In order to minimize potential mineral build-up and prolong the life of your steamer,
distilled or de-mineralized water is recommended when llingReservoir.
5. Replace Water Tank by pushing rmly up into the unit.
Always place steamer securely on the side when not in use. Do not rest steamer on other
surfaces or attempt to stand steamer on the Steam Nozzle or Base.
WARNING - Take care to not pinch your ngers or hand when replacing water tank into
unit.