ENGLISH
|
7
FABRIC STEAMING
CAUTION: When steaming any material for the rst time, it is recommended that you test
on a small inconspicuous area before proceeding. Do not use on synthetic fabrics such as
100% nylon or polyester, or other steam-sensitive materials.
NOTE: Be sure the Water Tank has already been lled before following these steps.
1. Plug power cord into a standard electrical outlet.
2. Power on and wait approximately 30 seconds until the Steam Status Light turns from red to
green, indicating the unit is ready to use.
3. Direct Steam Nozzle towards fabric material you wish to steam. See below for additional tips
and procedures.
CAUTION: Always be sure that Steam Nozzle is pointed in a safe direction (away from
yourself, other people, pets and plants) when steaming.
STEAMING GARMENTS:
•
Hang garment from a clean, rust-free hanger.
•
Direct Steam Nozzle towards bottom of garment. Steam will rise along inside and outside
of material, removing wrinkles. Slowly slide Steam Nozzle upward from bottom to top
of garment.
•
Direct Steam Nozzle away from garment and smooth material with your free hand.
•
Repeat as necessary until garment is fresh and wrinkle-free.
GENERAL STEAMING TIPS:
•
For most effective results, hold Steam Nozzle within 1/2” of fabrics, or press it directly
against surfaces.
•
Curtains and draperies can be steamed while still hanging.
•
To remove wrinkles from towels, handkerchiefs and napkins, drape them over a rod or
towel rack and gently steam them.
•
Heavier fabrics may require repeated steaming to achieve desired results.
•
To remove exceptionally stubborn wrinkles, steam both sides of fabric.
•
Be especially careful when steaming any delicate fabrics that may be damaged by heat or
water spotting.
When you are nished using your
s
teamer, immediately turn off and unplug power cord from
electrical outlet. Refer to STORAGE & CARE for proper storage and maintenance procedures.
To Next Page
Loading...
