6
|
ENGLISH
FILLING WATER RESERVOIR
1. Place Digital Fabric Steam Press on a flat, level surface.
2. Turn Locking Knob to “Unlock” position to unlock Pressing Plate.
3. Lift up Pressing Plate using Handle. It will automatically stay in lifted position.
4. Pull Water Reservoir out. Note that Water Reservoir cannot be completely removed from
unit; do not attempt to force it free.
5. Remove Water Reservoir Cap to expose Water Reservoir fill hole.
6. Using Measuring Cup (included), fill Water Reservoir up to the MAX (300 ml.) line with
distilled water.
7. Replace Water Reservoir Cap and push filled Water Reservoir back into main unit.
OPERATING DIGITAL FABRIC STEAM PRESS
1. With Pressing Plate in lifted position, plug power cord into
electrical outlet, and set On/Off Switch to “On” position
(FIGURE 1).
2. Identify type of fabric you are going to press, and select
corresponding temperature setting using Temperature Control
Buttons. NOTE: that it is best to start with the most delicate
fabrics first, as higher levels of heat will cause damage to
Nylon and Silk. Pressing Indicator Light will illuminate.
3. A few minutes of heating time will be required to reach selected
temperature. Once Pressing Plate is heated, Pressing Indicator
Light will deactivate. You are now ready to begin pressing.
4. Lay fabric flat on Ironing Board.
5. If pressing wool, you may choose to spray with a burst of steam.
This function is available once Steam Burst Ready Indicator Light illuminates.
NOTE: Do not activate burst of steam with unit completely closed, as this may damage unit.
Best results are obtained if Pressing Plate is held open approximately 3 in. (75 mm.) above
Ironing Board before pressing Steam Burst Button. For safety reasons, do not hold Pressing
Plate open more than 3 in. (75 mm.) when using steam burst function. Only use burst of steam
for 2-3 seconds for best results. If press is left on fabric for more than 10 seconds, it could
result in damage to the fabric.
NOTE: When using the nylon or silk settings, no steam is produced.
6. To press, lower Pressing Plate gently onto fabric and Ironing Board. Hold there for 8-10
seconds, then lift up Pressing Plate. Repeat until you have achieved desired crease and
smoothness. See page 7 of this manual for more specific pressing tips.
7. Once pressing tasks are complete, immediately set On/Off Switch to “Off” (O) position
and unplug grounded power cord from electrical outlet. Refer to page 8 of this manual for
further information about cleaning and storage of Digital Fabric Steam Press.
FIGURE 1
Using Your
Digital Fabric Steam Press
To Next Page
Loading...
