_________________________________________________________________________________
TOLO SAUNA info@tolosauna.com www.tolosauna.com
If steam generator is with humidity sensor, the steam generator will stop when the humidity
reach the setting value. (Notice: the humidity sensor is not in standard equip. Without
humidity sensor, steam generator works depends on the temperature sensor. If steam
generator works with humidity sensor, it will stop when the humidity reach the setting value.
If the humidity value lower 6 % than setting value, steam generator will start to heat again. If
no need humidity sensor, please pull out it from the control center box. Then turn off the
control center box and restart.
S11 Working time:
S11 timing functions: the default value is 45minutes. Working time is from 1~60 minutes and
“ ” (non stop).
S12 Celsius degree:
S12 shows the steam room temperature in Celsius degree.
S13 Heat preservation instructions:
S13 lights: shows the room temperature reaches 2°C higher than your setting value, then all
heating elements stop working, steam generator under heat preservation state.
S14 Descaling:
S14 lights: steam generator is off, going into descaling model. Descaling time is from 0~8
hours. “0” means automatically drain immediately, “1~3H” is waiting time, then drain, non
descaling function, “4~8H” is descaling model. Under “4~8H”, after you off the steam
generator, it will automatically pump descaling liquid into water tank for soaking. For example,
if you set 6 hours, it will soak with descaling liquid for 6 hours. When time reaches, steam
generator will start to drain, flushing, and then power off.
Figure 24
Pump working time:
1----30seconds
2----60seconds
3----90seconds
It was set well in factory according to the
different power of steam generator
To Next Page
Loading...
