STEFLY Canopy Flasher - Maintenance; Troubleshooting

SteFly Canopy Flasher Manual Version 1.2 11
If the flasher does not stop flashing shortly after landing (approx. 30 seconds) turn
off the switch manually. The same applies, if persons are arriving, who are not
familiar with the risk for the human eye of high-power LEDs.
6 Maintenance
The whole system consisting of SteFly Canopy Flasher, Control Box, on-off switch and cables has no
serviceable parts.
To obtain warranty service, please contact your local dealer or contact SteFly directly.
Opening the housing of SteFly Control Flasher or Control Box will void the warranty!
If it is needed to remove SteFly Canopy Flasher from the canopy, carefully begin pulling at the end of
the flasher housing (where the LEDs are placed). Take your time and 3M VHB Tape will slowly tear bit
by bit. Please contact us if you need new 3M VHB tape as spare part for reinstallation.
7 Troubleshooting
Problem
Possible Causes
Remedy
Canopy flasher does not flash
twice, when the on / off switch
is flipped to “on”
Battery is not connected to the
electrical aircraft system
Connect batteries
Battery voltage too low
Check battery voltage and
recharge / exchange it
Cables not properly plugged in
Reconnect the cables
If installed: canopy contact
loose
Check and adjust again that
both sides of the canopy
contact are in contact, if the
canopy is closed
Canopy flasher does not flash
in the air
FLARM baud rate not matching
Check if the baud rate of
FLARM and Control Box is the
same
FLARM is not working
Check if FLARM is connected to
the electrical systems
FLARM cable is not properly
plugged in
Reconnect the cable
Thermal protection
mechanism is activated
Let the flasher cool down