PRODUCT BRIEF INTRODUCTION
[ 11 ]
PRODUCT BRIEF INTRODUCTION
[ 12 ]
12. X-OVER AND EQ CHARTS.
13. EQ SETTING.
1.Red lines and slopes will change accordingly when
2.EQ all frequency points can be move left or right.For 20Hz-20KHz can be any Regulation.
Q volue=1-12.
HP/LP of crossover and EQ are modified.
11. READ.
To Read From Device(POS1-POS8).
8.REMOTE INTRODUCTION
9.TECHNICAL FEATURES
POWER SUPPLY
Voltange
8.5-15VDC
Idling current
1.5A
SIGNAL STAGE
Distortion - THD @ 1kHz, 1V RMS Output
0.01%
Bandwith @-3 dB
10-20kHz
Hight level input range 3V-15V
S/N ratio Full Power A-
INPUT STAGE
High Level(Speaker)
1.2.3.4
CONNECTION
From/To Personal Computer
1 x USB/B(1.1/2.0) 5M
CROSSOVER N.5(one each output channel)
Filter Type
Full/High/Low Pass /Band Pass
Slope Setting
6/12/18/24/30/42/48 dB
68 steps @ 20- 20kHz
Phase control indepent setting for each channel 0 - 180
Crossover frequency
98 dB
THD+N VS Power 1%
(СH1 CH2 CH3 CH4 ) 4X50W ATTS
To Previous Page
Loading...
