Steinbach APPcontrol HJ3012 - Page 34

Autostart mode
The Autostart mode lets you configure the autostart function.
F
2
4
1
5
6
2
4
1
5
6
7 7
3 3
8 8
Connection status
1
See "Start menu".
Start menu
2
Return to the start menu.
Autostart mode
3
Selects autostart mode.
-
Single cleaning starts the cleaning process once after the set delay.
-
Periodical cleaning starts the cleaning process immediately and repeats it at the same time at the
set interval.
Delay/Interval
4
Depending on the autostart mode, the selection field alternates between hours and days.
-
Single cleaning defines the delay until cleaning starts (1 to 23 hours).
-
Periodical cleaning defines the interval of periodical cleaning (1 to 10 days).
Confirm
5
Transmits the settings to the control unit.
Delete
6
Deletes the settings in the control unit.
Current mode
7
Indicates the current mode.
Time until next cleaning
8
Indicates the time until the automatic start of the next cleaning. Is only displayed if the autostart function
is active.
34