Steinbach Poolrunner - Page 37

Attaching the brush
1. Press the brush strip
6
into the recess
on the boom of the lter unit
3
.
2. Make sure that the brush strip
6
has
completely engaged and ts ghtly.
The brush is installed.
Removing the brush
1. Remove the lter unit (see secon "Cleaning").
2. Open all latches on the top part of the
lter unit.
3. Separate the top and the boom part of
the lter unit.
Only aach the brush if it can assist cleaning (e.g. for removing a biolm). In the case of
an incline, unevenness or too much dirt on the oor, the brush may have an adverse
eect on the cleaning result.
3
6
3
4
5
37