MIDEX-8
English – 31
ENGLISH
How it works
The MIDEX-8 supports two MIDI Thru modes and you can toggle be-
tween the two by pressing the MIDI Thru button.
• Mode 1: MIDI input 1 is routed to all MIDI outputs. The MIDI input LED 1 lights
up continuously.
• Mode 2: MIDI input 8 is routed to all MIDI outputs. The MIDI input LED 8 lights
up continuously.
❐
MIDI Thru is automatically switched off if an application program starts to
use one of the MIDI inputs or outputs.
Reset
• If you simultaneously hold down the buttons “Panic/Cablecheck” and
“MIDI Thru” for ca. 3 seconds, the MIDEX-8 will be reset.
❐
Activating the Reset function has the same effect as physically separating
the MIDEX-8 from the USB port by pulling the USB cable.
After such a reset, the operating system should automatically transfer the
firmware driver into the MIDEX-8.
❐
Under certain conditions, the Windows versions available at the time of re-
lease of this document, do cause problems in connection with resetting
USB devices. These are described in the following section.
To Next Page
Loading...
