MIDEX-8
English – 15
ENGLISH
Software Installation – Macintosh
Installing on the Mac – Important Information
Please definitely do read the following information before you start to
install the MIDEX-8 drivers on your Macintosh:
❐
Your Macintosh computer must be equipped with the necessary USB
port(s). It must run Mac OS version 8.6 or higher and provide sufficient
free space on its hard disk (min. 10 MegaBytes).
❐
Your Cubase or Nuendo version must be compatible with the LTB technol-
ogy. At the time of writing of this manual this was true for Cubase VST Mac
version 5.0.2. and Nuendo Mac version 1.5.2. If necessary, contact the sup-
port department of the Steinberg distribution in your country.
❐
Do not connect the MIDEX-8 itself before OMS and the MIDEX-8 drivers
have completely been installed! The system will otherwise not recognize it
correctly.
❐
OMS 2.3.8 or a newer version must correctly be installed on your computer
before you activate the MIDEX-8 Installer program, otherwise certain driv-
ers will not automatically be copied to the correct destinations in the Sys-
tem or OMS folders. An OMS installation program can be found on the
MIDEX-8 driver CD.
❐
If you are not familiar with OMS, please do definitely read the following
sections.
❐
If OMS 2.3.8 or higher is installed on your computer and if you are familiar
with OMS, you can immediately start to install the MIDEX-8 drivers, as de-
scribed under “Installing the MIDEX-8 Driver Software” on page 18.
To Next Page
Loading...
