13
Programmable in 1-button substa-
tions where the call button activates
the Doorbell function.
Master stations can be programmed
to receive doorbell calls.
MAKE A DOORBELL CALL
• Push the button on the door station.
- A tone-sequence is heard in the
door station and in the station(s)
receiving the doorbell call.
• Press the digit 5-key on any of the
receiving stations to establish
connection.
- The call request is cancelled if not
answered within 30 sec.
(2 minutes programmable).
• Two different tone signals may be
assigned to a door station to distin-
guish between door #1 and door #2.
• Receiving stations can be pro-
grammed to receive calls from door
#1 and/or #2.
REMOTE DOOR OPENING
The AB731 series stations have built-in
relays for:
- activating an electro magnetic door
lock
- local “station on” output for switching
on cameras, lamps etc.
• Press the digit 5-key in the receiv-
ing station during conversation to
activate the door lock.
• A call may be cancelled by press-
ing a button connected to the Local
Reset input in the door station.
Remote Output and
Door Opener
AA711, industrial stations AA703 -
AA705 and single button substations
in the AB731 series are equipped with
an internal relay which can be used
to control an electrical door lock or
similar.
All other stations must use an
external relay controlled by an
internal transistor output.
ACTIVATE REMOTE OUTPUT
• Call the station with the actual
remote output relay from a Priority
station.
- The called station must be pro-
grammed for this feature.
• Press the digit 5-key during conver-
sation to activate the door lock.
NOTE:
A station programmed for Remote
Output / Door Opener can not be
connected to an external loudspeaker.
Doorbell function
To Next Page
Loading...
