STEPCRAFT 210 - Emergency-Stop Switch; Operation of the System; Operating Elements; Optional Accessory; 6 Technical Data

14
NOTICE: Use additional handheld tools to remove hot filament from the machine table or the print head. Never
touch/draw the hot print head there is a severe risk of injury!
5.4 EMERGENCY-STOP SWITCH
The Emergency-Stop switch is located at the front side of the machine (refer to the schematics under item 3.1 of
these instructions).
If you press the switch the Emergency-Stop is released. The machine stops immediately (imperatively refer to
item 2.7 of these instructions).
NOTICE: Only press the Emergency-Stop switch in emergency situations!
If the switch is pressed it results in an immediate machine standstill and can result in step losses and data losses.
A controlled stopping of the machine can only be performed by means of the control software.
In order to undo the Emergency-Stop status turn the Emergency-Stop switch to the right. Thus the control is
reactivated. The working process has to be restarted.
5.5 OPERATION OF THE SYSTEM / OPERATING ELEMENTS
The whole system is controlled and operated by means of a computer or laptop (PC).
The minimum requirements are:
- Processor / CPU with 1 GHz
- 32 or 64 bit operating systems Windows® XP, Vista, 7 or 8
- USB 2.0 interface (no hubs / no USB connection cable longer than 5m / 15 ft.)
- Standard PC peripheral devices (monitor, graphic card etc.)
- Deactivation of power saving function, hard disk shutdown, frequency reduction
WARNING: Please completely read the manual of your control software before the first
commissioning and make sure that you understood everything.
For any further questions regarding the control software please contact the corresponding software developer.
5.6 OPTIONAL ACCESSORY
Please find additional accessories in our online shop at www.stepcraft-systems.com or www.stepcraft.us of your
STEPCRAFT such as:
- System-guided tools, e.g. drilling / milling spindle, cutting knife, plotter pen, engraving point, hot cutter,
3D print heads
- Extension of the modular unit control e.g. the 4
th
axis module together with the CNC rotary table
- Grooved plate (aluminium) or systems for mounting and clamping e.g. bench vice, clamping claws
- Tools for drilling / milling and many more
6 TECHNICAL DATA
6.1 DIMENSIONS AND WEIGHT
Type of machine
Overall size
(Length x Width x Height)
Travel distance
Weight
STEPCRAFT 210
340 x 342 x 350 mm
13.39 x 13.47 x 13.78 inch
210 x 210 x 40 mm
8.3 x 8.3 x 1.57 inch
11,0 kg
20.5 lbs
STEPCRAFT 300
430 x 345 x 410 mm
16.93 x 13.58 x 15.75 inch
300 x 210 x 80* mm
11.81 x 8.27 x 3.15
13,0 kg
20.5 lbs