Quick Start of T6 AC Servo
2.1.1.4 I/O input signal circuit.
A. The power supply is provided by user, DC 12-24V, current ≥100mA, if the power polarity
connects reversely, the drive won’t run.
B. If the drive is enabled by internal signal, then user won’t need to connect to Pin1and Pin2.
Pr4.00=83 for internal enable.
Pr4.00=3 for external enable.
2.1.1.5 I/O output signal circuit.
A. The power supply is provided by user, if the power polarity connects reversely, the drive will be
damaged.
B. The output circuit adopts open-collector, the maximum voltage is 25V, and maximum current is
50Ma. If user overlooks the requirements or output terminal directly connected to power supply, the
drive will be damaged.
C. If the load is inductive load, etc., anti-parallel freewheeling diode must connect to the load, if the
freewheeling diode connects reversely, the drive will be damaged.
D. Pin 31/32/33/34/35 are for single-ended output, pin 18/19, 20/21are for differential output.
2.1.1.6 Pulse input signal circuit.
Wiring method of 5V differential signal (Pin 3/4/5/6)
To Next Page
Loading...