6.- Channels
Allows you to jump next (+) / previous (-) channel
7.- Volume
Use to set the volume level
8.- Menu
Press to set Picture parameters
9.- Source
Press to change the input source
10.- LCR
Press to change to last channel received
11.- Down
Move down through the menus
12.- OK
Confi rms a selection
13.- Up
Move up through the menus
1. Press the TV / PC button in order to select the mode in which
you wish to operate the remote control.
a) If you select “PC MODE”, you can use the PC functions as
you normally would and you can ignore COM-250 and the
remote control. The monitor and the PC will be controlled by the
keyboard and the mouse as they normally would.
b) If you select “TV MODE”, the monitor will be controlled by
COM-250 by pressing the buttons on the front of the unit or the
buttons on your remote control. You can now use your PC
monitor as a TV and more. Select and adjust as shown.
ENGLISH
ENGLISH-12
To Next Page
Loading...